Webasto heater Air Top remote temperature sensor 5 meters| 1319842A | 9005004B

General information.

The heater optimum maintains desirable temperature if air temperature, flowing round temperature sensor, is close to air temperature in those rooms which need to be warmed up. But it isn't always possible, first of all because of features of an installation site of the heater. The external sensor of temperature which is installed directly in the corresponding part of the room is in that case used.

Suitable for Webasto air heaters including:

• Webasto Air Top 2000
• Webasto Air Top 2000 S
• Webasto Air Top 2000 ST
• Webasto Air Top EVO 40
• Webasto Air Top EVO 55

Kit includes

• Includes electrical plug and terminals
• 5 Metre Cable

Please note;

• For use with standard wiring harness 9003696

During repair or the routine technical maintenance of heaters can be in addition made the following work on re-equipment:

• Installation of the external sensor of temperature.

Installation.

Installation is made as follows:

1. To choose an installation site for the external sensor of temperature

Instruction:

• Temperature sensor on has to be installed so that it was directly blown by a stream of warm air, and not near heat sources (for example, the regular heater of the car);
• He should be established at average height in a cabin of the car and on a surface as close as possible to vertical;
• The installation site shouldn't be in an area of coverage of direct sunshine;
• The sensor of temperature shouldn't be installed curtains, etc.

2. To lay a plait from the external temperature sensor to governing body.

3. To remove resistance on a plait to be near the socket on governing body.

4. To pressure up a X8 socket block instead of remote resistance.

5. To connect the portable temperature sensor to a X8 socket block.

6. To turn on the heater and to check operation of the heater.