Autoterm Parts There is 1 product.

We offer the following Teplostar parts in our online store for sale.

• Control units - devices which provide control of the heater in conjunction with the control panel.The control unit performs the following functions: initial diagnostics (health check) of heater units at startup,diagnostics of heater units during the whole operation,turning on and off the heater on command from the control panel,set temperature control,combustion process control,automatic activation of the ventilation mode after the end of the combustion process,automatic shutdown of the heater: when one of the monitored units becomes inoperative, when the temperature of the heat exchanger, the supply voltage exceeds acceptable limits, when the flame breaks down in the combustion chamber.
• Temperature sensor for the heater Teplostar is necessary to monitor the operating temperature of the heater and monitor the correct functioning of the latter.
• Flame indicators - are used for pre-start liquid heaters 14TS-10 Teplostar, both for 12 and 24 volt versions of the device, for trucks, special equipment, buses, tractors.
• Combustion chamber the volume formed by the aggregate of engine or furnace parts in which the combustion of a combustible mixture or solid fuel takes place. The design of the combustion chamber is determined by the working conditions and the purpose of the mechanism / furnace as a whole; heat resistant materials are generally used. Meant to organize combustion process for fuel-air mixture.
• Air blower - consists of an electric motor with an attached snail. An impeller is mounted on the shaft of the electric motor from the side of the cochlea, and on the other hand, a fan.The impeller with a cochlea during rotation of the electric motor shaft forms a stream of air that enters the combustion chamber to provide combustion, and also purges the combustion chamber to cool and remove remaining fuel and moisture before starting and ending the combustion process.The fan creates a stream of air, which, passing through the radiators of the heat exchanger during heater operation, heats up and enters the vehicle interior.
• Remote controllers PU-11-12V and PU-11-24V are intended for use as part of the pre-heater 14TS-10-12V and 14TS-10, respectively.The remote control provides manual and automatic control of the heater, as well as the output of information necessary for the user to the indicator light.
• Glow plug provides ignition of the fuel mixture during heater start-up.The current consumption must be in the range from 3 to 5.2 A. The test time is not more than 90 seconds. The time between switching on is at least 180 seconds.It is forbidden to check a candle with a voltage of more than 24 V.
• Heat exchanger is designed to transfer heat from the hot gases generated from the combustion of the air-fuel mixture to radiators, which in turn transfer heat to the air flow passing along the fins of the radiators.
• Fuel pump - Designed for dosed fuel supply to the combustion chamber.The fuel pump is operated by electrical pulses sent by the control unit. The pulse frequency depends on the current heater performance.Fuel pump mounted on rubber shock absorber.The fuel pump is preferably mounted closer to the fuel tank and lower than the lower fuel level in the fuel tank.

You can purchase Teplostar parts listed above and other parts for it at our store. Why buy on our site? Because we offer only solutions which have been tested by time and Siberian winter. There are no little things in the field of autonomous heating.In areas where there is a lot of snow and cold spread for hundreds of kilometers, the cost of broken heating unit could be someone’s life! We offer worldwide international delivery, timely technical support and all the heaters we sell are subject to warranty from the manufacturer.Please,request any part directly by contacting us.